@DanAllred1 I’ve messed up a couple sets myself over the years they are challenging.
I’ll take no credit for these, my one guy who’s been a body man for 40 years does them now.
90% done ✔️
Good enough for the parade tomorrow.
Late 1976 1466, factory installed Coleman front end, 86 series bell housing, transmission case, axle housings, and wheel castings.
@gavin_spoor Well the 7250 budget 40-50k for every 1000-1500 separator hours.
The Gleaner you can have that damn rotor on the ground in 15 min.
I’d recommend a Deere but I’m not going to because I’ll get flamed.
There’s a story behind every ol Tractor.
Seems like just yesterday we got this beast of a JD 5020 Cummins onto our farm in Nebraska. But it was 2 years ago now and little did I know it would be the last tractor Dad & I got in together. Thank you to my good buddy @rroossinck for writing the story for us. If you’d like to give it a read here it is:
https://t.co/RnayQg9B2R
@NateLegler@PetersenFarms Speaking about grandpappy, since he writes the checks, he likes to do allot of the fieldwork. Can we send grandpappy out to eyeball the strips in or does he need pre mapped AB lines?