@Mrgunsngear This complex is DIRECTLY behind my neighborhood. This isn't the 1st, 2nd, or even 3rd shooting there. I was just chilling on my pc when that shot went off woke the wife up got her to a safe spot in the house and grabbed the good Ole bcm. Stay safe out there folks.
@esportsawards@OnsetMTH@Tasty_Steve@ubershouts The answer is Uber and if you think its not Uber take a second to think about how its Uber and you should vote for Uber.
Its Uber that is all.
@BaileyPizza Just filled out one that was upload resume, full out application with all the same information as resume, and then re upload resume in a different format.....
@geekay_esports I flet sick to my stomach when Ziyad had the DC. Im state side but if any of the Riyadh players need a out now they have a place to stay
Couple of requests for which thread adapter to buy for 3d printed suppressors.
It depends on which design, so read their PDF/readme
so... Generally for direct thread designs you will need one of these:
Thread Adapter 1/2β-28 to 5/8β-24
https://t.co/FwJVNDQiB5
or a
1/2-28 Female to 3/4-16 Male Thread Adapter
https://t.co/z6iCzm846A
Also get yourself one each of these
https://t.co/pgWz3J7Ybo
Fractional Plug Tap, 3/4-16 NF
and a
5/8"-24 UNEF Tap and Die Set Right Hand
https://t.co/vf5Oeri91N
You can "clean up" the threads on your printed can with these taps. If you are going to do it, put some effort into quality control. heh....