Team Shatterdome

FTC 8338 Team Shatterdome

[Mecha Dojo Robotics @MechaDojo]

Successful relic delivery! #OMGRobots

[QuadX 6299 @6299QuadX]

Had a good time at league meet one!

[S.M.A.R.T. FTC @FTC12520]

We completed the chain drive for one of our linear slides today! #OMGRobots #FirstInspires @FTCTeams @CliffordSmart @WalledLkSchools #wleced

[Mecha Dojo Robotics @MechaDojo]

Decision matrix was too close to call ... CAD team's solution : have both! #openEngineering Thank you @PTC_FIRST for supporting @FTCTeams

[Valley X Robotics @ValleyXRobotics]

Grippy grip

[FTC Browncoats 7842 @FTCbc7842]

Hey, look what we discovered! We found a new trick...a little late in the season. Better late than never, right? #omgrobots @FTCTeams

[Actobotics® @Actobotics]

NEW! Clean and solid way to mount your electronics directly to Actobotics components! https://t.co/hJsVIUqzGj #omgrobots #TipsforFTCTeams

[BlackDiamondRobotics @ftc9899]

If you're using new @REVrobotics electronics this year, your config files will look a bit different.

Don't worry: https://t.co/4Q8IGv9aAx

[Team Shatterdome @FTC8338]

https://t.co/iGEyshTzvH
Our team's season wrap-up / Thank-you message. Please check it out! Love, from Team @FTC8338

[Actobotics® @Actobotics]

Looking for a way to create linear motion? Here is an excellent option using a rotational servo! https://t.co/d0sImRE2mb

[Team Shatterdome @FTC8338]

Season 16-17 is over! The Velocity Vortex season was full of great successes which made us grow. Thank you, and wait for it...! #Newbies

[Valley X Robotics @ValleyXRobotics]

Support those USBs with our new supports for your new @REVrobotics Expansion Hubs! @FTCTeams @AZ_FTC https://t.co/NpZAi9biQE

[8719 Quantum Leap @QL8719]

@FTC8338 Thank you for teaching us all about King Sejong!

[Team Shatterdome @FTC8338]

Come find King Sejong - Take a picture!

[Team Shatterdome @FTC8338]

We're here. At the center of Edison Division area - Pit 8338!

[Team Shatterdome @FTC8338]

We're in Chicago!!

[FTC 5484 Enderbots @5484FTC]

What?! Can't use LED's to signal drivers? How about a tape measure on a servo? #ftc #omgrobots #tbtoresq #velocityvortex

[Team Shatterdome @FTC8338]

Dragoon V2 is finished, and we're leaving in 24 hrs for St.Louis!!! See you there, Edison division teams! Woo Hoo!!

[Team Shatterdome @FTC8338]

Dragoon V2 is ready for the St.Louis World Championship - Only four days to go!!!!!

[Team Shatterdome @FTC8338]

@CatheyRobotics Thanks! The drivers are working on capping the center vortex in 30 seconds, and we're successful so far.