krcrear

[krcrear @Li2K_N]

666终于线下到主播了@MscvWv

[krcrear @Li2K_N]

这是我的小狗@MscvWv

[krcrear @Li2K_N]

@MscvWv 汪汪

[krcrear @Li2K_N]

@Feifeihaose @MscvWv 一直吃的这么好

[krcrear @Li2K_N]

@Yours_Green 怎么刮的毛啊 真心求��程

[krcrear @Li2K_N]

@SonyaHebb863483 私一下

[krcrear @Li2K_N]

@baoguangwu 哇塞

[krcrear @Li2K_N]

@Benathon @blind_via you can also place a 100 ohm resistor and the differential signal next to the chip where you need to use the single-ended signal, connect the differential pair to both ends of the resistor, then connect the differential pair + to the input, and ground the differential pair -.

[krcrear @Li2K_N]

@Benathon @blind_via When you need a single-ended signal at the chip, use a differential signal and a balun next to the chip. Connect the differential pair to the balun, and then connect the balun's single-ended output to the input.

[krcrear @Li2K_N]

@rtt2636 258