@krispykriskring Yea, it’s a lot of fun. I designed and built intake systems and cylinder heads for high performance boats and sand rails backing in the early 2000’s. I I never had to deal with the factories, just SEMA for the stock solid models. 95% of the power an engine makes is in the heads
@TruckerDanUSA That’s an early to mid 30’s hard tail frame, probably held an 80ci flathead
motor. They’ve obviously put a modern evo or S&S in it. Too bad, the old flathead was a good engine. The bike would have been very valuable if he’d restored it.
@VCradier@MakePint@indi500fan1@mechanical_4u I remember reading about an obscure supercar that bolted an electric motor directly to the crankshaft of a 600hp V8. They were electronically synchronized to augment each other. In this case, the goal was horsepower, around 1200hp. Similar, but less sophisticated.
@VCradier@MakePint@indi500fan1@mechanical_4u OK, I get it, the CVT is achieved through the electric motor with the gas engine mechanically coupled and electronically synchronized until a condition is reached where it can operate efficiently. The concept is very straightforward, implementing it is rather complex.
@VCradier@MakePint@indi500fan1@mechanical_4u OK, I just looked at the Toyota Highlander hybrid CVT transmission and it’s a belt drive. What makes it different is the belt. They seem to use some sort of metalized composite material. That’s it on the right
@FrankBr05713205 Somewhere in storage I have one from my dad, It’s really old. It’s made of ivory and slide is silver with a crystal lens. It must have been made in the early 1900’s
@MakePint@indi500fan1@mechanical_4u I believe it, Toyota doesn’t put something on the road that’s not reliable. My daughter has a 2019 Subaru with one. It’s been very reliable. Nissan however has had nothing but problems. I’m an old hot rodder, I just don’t like em.
@indi500fan1@mechanical_4u Not a big fan of CVT. I followed the early development of Mercedes and Subaru, basically a belt drive like some drill presses except metal and hydraulics. The early ones were metal on metal, not a good setup for reliability.
@3DEtchASketch@Mileage_impo Is the finish too rough? In that case you would want to go with the heaviest oil you’ll can get away with. A pushrod engine can handle a fairly heavy oil. Unlike DOHC engines with VVT.