Roger Hürzeler

[Roger Hürzeler @TheEquah]

This shredder from @Filamaker arrived today. I would like to make some experiments about recycling various materials in the comming months...

[Roger Hürzeler @TheEquah]

Painted black, it looks even greater.

[Roger Hürzeler @TheEquah]

Just arrived yesterday. this aluminium profiles look so beautiful 😍
It will be the first time working with these.

[Roger Hürzeler @TheEquah]

Already working on the next part of my room setup project 😉

[Roger Hürzeler @TheEquah]

After a long break in this project, I'm now continuing to work on it and present you the next part, which describes the primary desk, to which I've done some modifications.

https://t.co/69oF62zqqJ

[Roger Hürzeler @TheEquah]

Here is the post of the shelf electronics which controls a major part of my room setup project. Sorry for the delay, I had a lot of things going on lately and was also working on other projects.

https://t.co/gmTGFuMzGx

[Roger Hürzeler @TheEquah]

@Raspberry_Pi There are a lot of great cases. But just some days ago I printed a mount, since I didn't had any screws which fitted the PCB holes.

[Roger Hürzeler @TheEquah]

Surely enough #Arduino boards for my project. Post about the "Shelf electronics", which is a part of my room setup project, will be published next weekend.

[Roger Hürzeler @TheEquah]

The ambition is to control electronics (shutters, lights, monitors, computer etc.) over the network on a web interface hosted by the #RaspberryPi.

[Roger Hürzeler @TheEquah]

Just startet experimenting with serial communication from my #RaspberryPi to #Arduino to allow the control of electronics in my current room setup project.

[Roger Hürzeler @TheEquah]

On my first blog post I already mentioned the "Personal desk" project. The concept of this has completely changed and is now the "Room setup" project. Here is the introduction to this...

https://t.co/7b50NOOipY

[Roger Hürzeler @TheEquah]

The introduction to my first project which will span over multiple blog posts will be published soon. Untill then, here a picture of a gear I'm currently printing which is only a small, but important part to it...

[Roger Hürzeler @TheEquah]

A bit delayed, but here it is. Setup of Palette+ by @MosaicMfg with my #FABtotum 3D printer by @FABtotum.

https://t.co/0a7zsXg2G7

[Roger Hürzeler @TheEquah]

Still encountering some problems with the print. But I will continue working on it next weekend. So the blog post will unfortunately be delayed...

[Roger Hürzeler @TheEquah]

Calibration of the Palette+ by @MosaicMfg with my #FABtotum. Blog post about the whole process as showing off some printed models will probably be published next weekend.

[Roger Hürzeler @TheEquah]

A small piece of filament was stuck inside the teflon tube, where the filament is welded together.

[Roger Hürzeler @TheEquah]

I encounteres some problems, while setting up Palette+ for my #FABtotum...

[Roger Hürzeler @TheEquah]

The setup of my new FABtotum 3D printer. I already printed a few things and I'm happy with it's quality, but will further optimize it.

https://t.co/QkzAHWFHGX

[Roger Hürzeler @TheEquah]

Publication of my first blog post. In this post I introduce my blog and describe the topics as well as upcoming projects.

https://t.co/T5g1gFJVzV