It’s happening tomorrow folks… come join the fun as I get asked to answer a bunch of both fun and uncomfortable questions… Nothing is off the table! It’s going to be a blast… https://t.co/uHvblVEX0o
I did an impromptu coding livestream today on the NeoXSegment library - I got some animation control happening + extra stuff. It’s hard to code on stream, but i’m getting better at it…
https://t.co/qP8rF56IdX
Just designed and routed an awesome PCB today…. can’t spill the beans yet as it’s for an up-coming project, but wowza, SOOOO exciting! Oh, I am also using 0603 passives on it, for the first time!
#maker#electronics#eaglecad#pcbdesign
It’s going to happen folks! You’ve all inspired me to get my ESP32 dev board finished and into fabrication.. I’m going to do it all live 7am (GMT +10) tomorrow…
https://t.co/I0ziW1LPL2
#maker#livestream#electronics#completions
I’m starting to use #ifdef … #endif in my code more to compile out code I don’t need, rather than just using standard if’s or bulk comments.
Then I can just enabled it or disable it by defining a symbol, like DEBUG or MASTER etc..
#maker#code#arduino#tips
Just a reminder… live stream starts in just under1 hour. I’m live coding my Neo7Segment library and showing off what I have so far.
https://t.co/0hg1tMaW1y
#maker#livestream
Reminder: Live stream starting in 1 hour - I’m going to go over my custom SMAD21 dev board and make some important changes to improve battery drain.
https://t.co/jCn7Q4P89G
#maker#electronics#livestream