Goofy face, goofy stache. Help me raise funds for men’s health by donating to my mo space. Link in bio, thank you all for your generosity. https://t.co/xFW6V4EACv #movember#moustache#menshealth https://t.co/9BTaNYOKE0
Happy birthday to the most beautiful and wonderful wife in the world. Love you to the moon and back. #happybirthday#wifedrivingboat#glasspar https://t.co/zzlS0XFufR
The 19th hole is now sporting some new clothes. Ordered this new cover on amazon for a decent price. It doesn’t fit perfectly, but it’s much better than the crappy ripped up Canadian tire one that was on it before.… https://t.co/FRjOoWkLeq
Little update on the 19th hole; she starts super easy and runs so beautifully. We took grandma out for a tour around the lake today. The old merc has about 5-1/2 hours of run time so far. One thing I noticed is that… https://t.co/PuK0zHVBnZ
A man and his boat, nuff said. Almost done the 2 hour idle break in, then we can run it gently at cruising speed for the next 6-8 hours. At 25:1 fuel mix, there isn’t a mosquito for miles; at least you can find me… https://t.co/GSSDyJ1fI2
She’s finally done, in less than 48 hours, she’ll be on the water again pending an idle speed and ignition timing adjustment. I have always loved the look of this era of merc motors, the detail, colours, the fact… https://t.co/rQmw0dCTcH
After a couple long and extraordinarily frustrating hours of adjusting the carb floats, I finally got to hear my baby run for longer than 20 seconds. I adjusted the idle mixtures so the motor actually runs smoothly… https://t.co/0mHQrnIEHI
Since I’m stuck on the motor until I get parts, I replaced the taillights after some idiot (me) managed to break one trying to get the trailer out of the tent last time. I also repacked the wheel bearings with fresh… https://t.co/vaf5VSREEL
Put new plugs in the old girl and she sang like a choir of angels for a whopping 20 seconds until it sputtered to a stop and refused to start. So I checked the obvious, had good spark, had fuel going into both carbs,… https://t.co/NkMEWaZCsV
More progress today but not as noticeable. I had to take the exhaust baffle plate back out to seal it up better so it doesn’t corrode the baffle plate. I also finished off the carburetors and installed the… https://t.co/lwX5rJD6LD
End caps are on, end play is set, I had to remove a shim to make it perfect. And a little message that will probably not be there if someone goes to open up this motor again. It’s the thought that… https://t.co/W1mkhPr9VC