Aaron

[Aaron @AaronJBuegge]

@Catriona_Rtree @OwenLangley19

[Aaron @AaronJBuegge]

@R2Kovac Gabriel st Cloverdale is not the place to come?

[Aaron @AaronJBuegge]

@BlacketPeter @Tedthekelpie https://t.co/QAZKaGnsr3

[Peter Unger @mvagriculture]

With all the right tools removing duals is a simple one person job. Rims being sent away for new centres. Cracking around the holes. Seem to be a common fault on 8120 with duals. A frustrating, cost that I'm not sure we should be covering. #caseih

[Aaron @AaronJBuegge]

@JasonSyred Show us all “The” canola paddock 😉

[Aaron @AaronJBuegge]

@katfleay Still got the canoe 🤔

[Aaron @AaronJBuegge]

Very lucky to have @R2Kovac in town, hydraulic hose repaired in paddock, up and going again 👏👌👍

[Aaron @AaronJBuegge]

@R2Kovac @BradenBagley

[Aaron @AaronJBuegge]

When you’re helping a mate for the day, it’s important to establish your dominance early #paddockalpha @ARMartin_Marty @morellafarms1

[Darren Kilminster @darrenkilla]

#AskTwitter @CaseIHAus . Issue with 7240. Pto pump fault codes keep coming up. All filters changed, bar pressure off PTO has been manually checked and running at 22.5 bar. But on pro 700 its ranging from 8 to 21 bar. Cuts out rotor and feeder , wiring loom good.
Any ideas.

[Aaron @AaronJBuegge]

@Drakey04 Thanks Mark, what size simplicity?

[Aaron @AaronJBuegge]

Looking for advice, anybody running a tow between box behind a fwa tractor? Can’t have much ballast on the front of the Magnum so not sure it would enjoy it...

[Aaron @AaronJBuegge]

@glen_keeffe @CaseIHAus Mind you looking at yours, i doubt they will buy that off you, bit far gone...

[Aaron @AaronJBuegge]

@glen_keeffe @CaseIHAus Stw tyres in Perth have them in stock, buy your old one off you, cut the centre out and put a thicker plate in there, just be careful if replacing both as the ones I picked up this year were 20mm thick and I run out of thread to get the wheel nuts on!

[Aaron @AaronJBuegge]

@jcan78 Thanks Jerome yeah that does make me think of the John Deere rotary screen setup, maybe after harvest I’ll come check them out, or buy a green one 🤷‍♂️

[Aaron @AaronJBuegge]

How is everybody getting on with the new #iHSD, we are having a lot of trouble with the dust created blocking up the radiator, also had problems dealing with barley and canola straw blocking up at choke point over the baffle, only have a beater in my 9120, chopper in 2020? $$$

[Aaron @AaronJBuegge]

@AlecBowyer Yeah Alec our first windy day when we were on barley had us blowing out the radiator on a regular basis, fine going one way, then turn around for next run and she sucks it in a gets hot!

[Aaron @AaronJBuegge]

@Teabag092 @agriprof Good to hear Nick!