Andrew Reynolds

Farmer, Muresk Graduate, Ex-Agronomist

[Andrew Reynolds @Agro_Andy]

@Ashley_Jacobs92 @abfarmdawg 100% better than the original, but not as good as the Hypro one would be. When I put them on I didn’t have the time to run extra plumbing to make the Hypro fit without it sticking too far out to the side by just turning the nozzle holder 90 degree’s would make it prone to damage

[Andrew Reynolds @Agro_Andy]

@Ashley_Jacobs92 @abfarmdawg This was my solution after the same issue with the fence line nozzle Ashley, Square 110L cut up. Does the job perfectly and weigh nothing 👌

[Andrew Reynolds @Agro_Andy]

@GribbleRC Hi Rob. We got the straight bars and half moon brackets to suit a D65 and put on our D145. It made a considerable difference as we could then put a bit of rubber 400mm wide on them as a paddle. Still not great but better than what ever we mounted on the original spiral.

[Andrew Reynolds @Agro_Andy]

@jackatgroundhog Hi Jack. Will you be making these to fit the 42mm tubes on the older bars as well?

[Andrew Reynolds @Agro_Andy]

@JamieNicolaou Thanks for the reply, always interesting to understand how people kill barley grass without killing the Ryegrass, not something we have to worry about in the wheatbelt where the rye is harder to kill 👍

[Andrew Reynolds @Agro_Andy]

@JamieNicolaou Hi Jamie. How did this brew end up? Did it have much effect on your ryegrass? I assume your Rye is improved/sown and not just naturally occurring/wild?

[Andrew Reynolds @Agro_Andy]

@DrJewmelon @KondininGroup When do you expect the data/research report be published for this latest round of testing?

[Andrew Reynolds @Agro_Andy]

@Voz_Dennis Yes please Dennis

[Andrew Reynolds @Agro_Andy]

@Tedthekelpie @hirschirsch @cropmad @burgess_ag @CraigGorfin @venningj @nozzlesonline @GoldacresAust Electronics

[Andrew Reynolds @Agro_Andy]

@hirschirsch @cropmad @burgess_ag @CraigGorfin @venningj @nozzlesonline @GoldacresAust Surely if it was that simple they would be all over it already? Would be a fantastic alternative to PWM Turn compensation which is about the only thing that would push us into an SP over the Tug along. A 10,000L tug along with non PWM Turn compensation would be my dream!

[Andrew Reynolds @Agro_Andy]

@hirschirsch @burgess_ag @CraigGorfin @venningj @nozzlesonline @GoldacresAust If someone could work out Turn Compensation without the need for PWM at the nozzle, I would buy one tomorrow, extra points if it’s a tug along 👍😂

[Andrew Reynolds @Agro_Andy]

@Rocket0764 @ipaddockapps iTechWorld JS80 3000Amp, even starts FWA tractors and Trucks provided they aren’t dead flat. Also have one as a battery pack in the car to run Engle when car turned off, gets 4-5hrs of life out of it when set at 2 degrees 👍

[Andrew Reynolds @Agro_Andy]

@CurtisGuthrie15 @FouldsCourtney Also couldn’t work this out, can’t log into the dashboard to cancel. After 6 months of sending Andrew emails (with no reply) asking them to stop direct debiting my card, I rang the bank and had to block the card (something to do with the direct debit set up AgriTrack use).

[Andrew Reynolds @Agro_Andy]

@mdfowler100 We have had ours for a couple of years now so unsure on $, worth the investment compared to wrecking a conventional Auger with Fert

[Andrew Reynolds @Agro_Andy]

@LIamaOfDoom @GribbleRC @CaseIHAus @NewHollandAG It has air pressure sensors above and below top sieve to determine load on sieves. Shows as a bar next to loss/MOG/cracked Grain/tailings funnels. Can also put Left and Right pressure readings on run screen to see if header is loading up one side of the sieves 👍 great in canola

[Andrew Reynolds @Agro_Andy]

@HallRaelene Andrew Reynolds, Beverley. Thank-you

[Andrew Reynolds @Agro_Andy]

Thanks Phil, I’ll have a look into it. It certainly is a shame to see what’s happened with Agritrack. Such a useful and simple tool for managing multiple machines/employees. Needs you back at the helm!!

[Andrew Reynolds @Agro_Andy]

Has anyone found an alternative to @AgriTrackAU ? Preferably one that works and has some description of backup/support for when it doesn’t? We run predominantly case gear.

[Andrew Reynolds @Agro_Andy]

@burgess_ag I’m not really sure, it’s the most confusing piece of shit GPS we have, but with those settings we don’t seem to get green strips with our boom (9036). Also have the coverage switching overlap at 99% (whatever that means) 😂