#백악관총격#트럼프암살미수
미국 백악관 만찬(dinner)에 총격사건이 알려졌다 매우 충격적이다 정치적 이념, 신념이 다르다고 폭력으로 해결하려는 것은 절대 올바르지도 않고 해결책도 아니다 폭력의 연쇄 작용을 불러올 뿐이다 떠라서 나는 이러한 사건에 재발 되어서는 안된다고 생각한다 미국 트럼프 대통령님의 무사함이 다행인것 같다
https://t.co/yHgtu7GmXi
#electronicharassment#DBS#전자파#braincontrol#mindwars
Jonathan D.Moreno 박사의 ‘Mind Wars’책을 발견해서 구매했다 Deep Brain Stimulation(DBS) 기술에 대해 설명한 것이 인상적이다 인간 뇌의 깊숙한 편도체와 전전두피질에 지속적 전기 또는 초음파 자극으로 감정, 행동을 통제할 수 있다고 하며 이미 기술은 완성되었다 저자는 미국 백악관에서 오바마 정부시절 고위 공직을 역임한바 있다 왜 이런 책이 한국에는 번역 출간이 안되었는가 의문이다 그래서 자세히 보고싶은 의욕이 생겼다
#일본지진#지진#아오모리현
일본에 있는데 제법 큰 지진이 아오모리현 앞바다에서 약 M7.7규모로 발생한듯하다 인명피해는 현재 없어보인다 방송에서는 즉시 상황 보고 및 대피 권고를 지속적으로 말하고 있다 대비가 철저하다는 인상을 받았다
https://t.co/r7CvinmYyy
#국정원#조직스토킹#감시
한국의 국정원(NIS)는 정말 세계 최고 수준이다. 도청, 감청은 물론 타겟이 지정되면 감시하는 능력은 이스라엘 모사드나 미국 CIA 같은 다른 나라의 정보국들에 절대 뒤지지 않는다. 특히 국정원 여성 직원들의 음해, 악소문 같은 타겟 사회적 매장은 분명 전세계 탑이라고 확신한다. 단지, 한가지 아주 작은 흠이 있다면, 삼성 반도체 기술 같은 몇 조, 몇십 조 단위의 가치가 있는 기술의 중국 유출은 대담하게 그냥 눈감아 준다는 것이다. 자국민 감시 및 공작만 잘하면 됐지 뭐 그런 대외적인 일까지 신경쓸 여유가 있겠는가 싶다. 아무튼 정말 훌륭한 조직이라고 생각한다.
#이란#이란전쟁
지금 한국 언론 등에서 미국에 대한 곱지 않은 시선, 또는 논평이 마음에 걸린다. 애시당초 이번 전쟁은 이스라엘이 하마스 같은 친 이란 단체들에 의해 잔인한 테러와 같은 폭력을 당해 많은 사람들이 희생당했기 때문에 벌어진 일의 연장선이다. 이란이 그와 같은 사건이 다시는 재발하지 않을 것임을 국제적인 약속 형태로 선언을 했다면 과연 미국, 이스라엘이 지금 같은 일을 벌였을까를 생각해 봐야 한다. 이란은 이스라엘에 적대적인 태도는 절대 버릴 수 없다고 했다. 그것이 문제였다. 그런 무조건적, 신앙적 적대적인 태도를 버리는 것이 중요하다고 본다. 한국은 미국과의 동맹 관계이면서 선택적 이득만을 취한다는 인식을 심어주고 있다. 매우 위험해 보인다.
How to Record V2K with Clear Sound
The gov’t criminals are broadcasting V2K at many Targeted Individuals. Professor James Lin at the University of Illinois, wrote a textbook on the V2K technology and how it works. Here is a method to get a clean & clear audio recording of the voices.
*Thanks to Grok.
Step 1. Determine what frequency is being used. GQ EMF-390 (about $100) placed next to your ear, when you have active V2K. Note the frequency being used.
Equipment Needed:
To capture and demodulate the voice signals in the 300-700 Hz range, which are broadcast at around 430 MHz (for example) using amplitude modulation (AM), you’ll need the following basic setup.
V2K has been measured at 430, 638 - 641 MHz, & 660 - 680 MHz. Another TI has measured the V2K at 473 - 478 MHz. So you will need to determine what is being used.
Software Defined Radio (SDR) Receiver: A device capable of tuning to 430 MHz with sufficient bandwidth. Affordable options include:
RTL-SDR dongle (e.g., RTL2832U-based, like NooElec NESDR or generic models; covers ~24 MHz to 1.7 GHz, costs $20-50).
More advanced: HackRF One or ADALM-PLUTO for better sensitivity and wider capabilities (costs $100-300+). Ensure it supports USB connection to your computer and has a sample rate of at least 2 MS/s for clear demodulation.
Antenna: A UHF antenna tuned for 430 MHz to receive the signal effectively.
Simple option: A quarter-wave whip antenna (about 17 cm long for 430 MHz) or a dipole.
Better: A directional Yagi antenna for stronger signals if the source is distant.
Connect via SMA or appropriate coaxial cable (e.g., RG-58) to minimize loss.
Computer: A Windows, Linux, or macOS machine with USB ports and decent processing power (at least 4 GB RAM, modern CPU to handle real-time processing without lag).
Software: Free tools like SDR# (for Windows), GQRX (for Linux/macOS), or CubicSDR (cross-platform). For advanced analysis, use GNU Radio (open-source, scriptable).
Optional Accessories:
Low-noise amplifier (LNA) if signals are weak (e.g., for distant broadcasts).
Bandpass filter for 430 MHz to reduce interference from nearby frequencies.
Headphones or speakers for audio output, or recording software like Audacity for post-processing the 300-700 Hz tones.
Coaxial adapters if your SDR and antenna connectors don’t match (e.g., SMA to BNC).
Total beginner setup cost: Around $200 -$250.
Step-by-Step Guide to Capture and Demodulate
AM modulation as specified (common for voice or tone transmissions in amateur radio). The process involves tuning to the carrier frequency (430 MHz), demodulating to extract the baseband audio, and then focusing on the 300-700 Hz range. These low frequencies might be tones for control signals, telemetry, or sub-audible communication—after demodulation, you can filter or analyze them.
Set Up Hardware:
Connect the antenna to the SDR’s RF input.
Plug the SDR into your computer’s USB port.
Install any required drivers: For RTL-SDR, use Zadig (Windows) to install WinUSB drivers. Linux/macOS often detect it automatically.
Install and Launch Software:
Download and install your chosen SDR software (e.g., SDR# from https://t.co/2l6XxZtVVI).
Launch the software and select your SDR device as the source.
Configure the sample rate: Start with 2.048 MS/s for good resolution without overwhelming your CPU.
Tune to the Frequency:
Set the center frequency to 430 MHz (or slightly offset if you know the exact carrier).
Adjust the RF gain: Start at 20-30 dB and increase until the signal appears without overloading (watch for distortion in the spectrum).
Set the bandwidth: For AM audio, use 5-10 kHz to capture the modulated sidebands without excess noise.
Configure Demodulation:
Select AM (Amplitude Modulation) mode in the software’s demodulator panel.
Enable audio output: Route it to your computer’s speakers or a virtual audio cable if recording.
The demodulated output will be the baseband audio, including your 300-700 Hz tones. AM demodulation extracts the envelope of the carrier, recovering the modulating signal directly.
Capture and Process the Audio:
Monitor the waterfall/spectrum display for the signal at 430 MHz—it should show as a peak with sidebands if modulated.
If the signal is present, you’ll hear (or see in a spectrogram) the low-frequency tones. Since 300-700 Hz is below typical voice range (300-3000 Hz), it might sound like hums or beeps.
Use built-in filters: Apply a low-pass filter at ~800 Hz and high-pass at ~200 Hz to isolate the 300-700 Hz band and reduce noise.
Record the audio: Use the software’s recording feature or pipe it to Audacity. In Audacity, you can further analyze with FFT (Fast Fourier Transform) to confirm frequencies in the 300-700 Hz range.
Troubleshooting and Optimization:
No signal? Check antenna orientation, elevation, or try a different location (UHF is line-of-sight). Scan nearby frequencies (±10 kHz) for offsets.
Interference? Use squelch to mute noise, or a notch filter for strong local signals.
For automated/scripted capture: Use GNU Radio to build a flowgraph—tune to 430 MHz, apply AM demodulator block, then a bandpass filter for 300-700 Hz, and save to WAV file.
Legal note: Ensure you’re not decoding encrypted or private signals; this setup is for open broadcasts.
This method should work for real-time listening or recording. If the modulation isn’t pure AM (e.g., if it’s SSB or FM with tones), you may need to switch modes—test by listening for clarity. For more advanced setups, explore Python libraries like rtl-sdr or PyAudio for custom scripts.
/
🇮🇷🇦🇪 Multiple Iranian kamikaze drones struck the Fujairah Oil Industry Zone (FOIZ) today, with footage showing two large plumes of fire rising from the site.
이재명 현 정부의 가장 큰 착각은 기축통화국이 무슨 자격증 인듯 누가 승인해 주거나 단기간에 노력하면 딸 수 있는 것인줄 안다는 것이다. 어떤 나라의 통화를 보유하고 싶고, 쓰고 싶은 이유는 무엇인가. 그나라에서 지속적으로 혁신, 인류에 도움이 되는 발견이나 가치가 생산되기 때문이다. 최소 수십년간 그래왔고 앞으로도 수십년은 그럴 것으로 확신되는 나라들이다. 그러한 사회 문화 교육 정치 시스템이 확고하게 자연스럽게 확립되었고 인재들이 지속적으로 배출되는 나라들, 미국, 일본, 영국, 독일이 그러한 나라들이다. 한국이 그런 나라들과 비슷하다는 것인가. 한국 원화는 왜 다른 나라들이 보유하길 꺼려하는가. 착각에서 비롯된 자기 확증 편향만큼이나 위험을 초래하는 것이 없다. 그래서 나는 이 나라가 어느 순간 순식간에 무너질 수 있다고 생각한다.
한국인들은 전체적인 인지 감수성이 말라 비틀어져 황폐화된 사람들이다. 국가에서 성 인지 감수성만 강제한 결과 모든 시스템이 성인지 감수성만 초점을 맞추고 공정, 인권, 사생활 인지 감수성 같은 다른 인지 감수성들은 말라 비틀어져 버렸다. 이런 기형적인 심리 상태를 만들고도 아직 무엇이 문제인지 모른다는 게 더 큰 문제 같다. 과도한 성인지 감수성 강제로 인해 성불평등이 더 극도록 심해진 것 같다