CPG Tech

When you have questions, we have answers. Fully trained techs from COMP Cams, TCI, ZEX, FAST and the other CPG companies are waiting to answer your questions.

[CPG Tech @CPGTech]

@seprico622910 We do not have cams for the 4.7.

[CPG Tech @CPGTech]

@Richard14128811 Judging by the wear near the bolt holes, that is a used part. Was it purchased directly from TCI?

[CPG Tech @CPGTech]

@kaloguesr Hard to say. Give us a call and we can give you some tips!

[CPG Tech @CPGTech]

@victorgaragesmg 1601: strongest possible (full roller), but the 1412s will prob handle anything you need. 19001 will work, needs tall valve cover.

[CPG Tech @CPGTech]

@faspit Send us a message with your email address, and we'll get the instructions to you ASAP.

[CPG Tech @CPGTech]

@rlpets We do have EFI for Ford manifolds. The two configurations are: Throttle body injection with our EZ-EFI & multiport EZ-EFI and XFI systems.

[CPG Tech @CPGTech]

#HappyHalloween

[CPG Tech @CPGTech]

@PaulHaaker A @FASTEFI XDi Dual-Sync is the way to go. Pt # 305009 at https://t.co/iw0QOOifL7

[CPG Tech @CPGTech]

@DodgeD150 You should speak with a tech at 800-999-0853. They will have several questions to make a recommendation. Or, message us your contact info.

[CPG Tech @CPGTech]

@GlennSortor The 743861 is a full length Gm dipstick with a locking cap.

[CPG Tech @CPGTech]

@Adambath No, the inner springs will need to sit on a flat surface. That step must be machined off.

[CPG Tech @CPGTech]

@miglaswyvern NS 6541 is the diesel kit solenoid

[CPG Tech @CPGTech]

@chase_ti use cam button, set end play .004- .010

[CPG Tech @CPGTech]

@FerrallJustin 10-12 degrees BTC

[CPG Tech @CPGTech]

@itsjuniorj United Speed World 813-264-4460

[CPG Tech @CPGTech]

@badolds455 Also, if a longer valve has been installed, it will change geometry. But if everything is stock, you will be good to go with those pushrods.

[CPG Tech @CPGTech]

@badolds455 Those pushrods will work as long as the block & heads haven't been milled excessively or angle milled.

[CPG Tech @CPGTech]

@BrascoeSFC The lift for cam # 08-423-8 is figured with a 1.5 rocker ratio.

[CPG Tech @CPGTech]

@badolds455 You can use rocker arms 1242-16 with the CL42-228-4. The part # for pushrods is 7845-16.

[CPG Tech @CPGTech]

@ChaseA_86 The lifter part # is 812-16. Or if you want cam and lifters in a kit, the part # is CL12-235-2.