This week has seen slow methodical progress on rebuilding my office. Realized that putting down flooring first would be foolish, so insulation, drywall, texturing, baseboard removal, and paint were priority.
Now onto flooring.
@svperfecta@CzarneckiD The 49โ Samsung CRG9 Odyssey is ๐ฉโ๐ณ. Normally I also have a 34โ LG above it, but Iโm ready to get my big monitor back. ๐
Iโm here until the place burns down, but since I actually wanna talk to most of yโall in the after, my Mastodon is being setup here:
https://t.co/24LV0IGxMb
Back from my vacation to resume work on my flooded office. Tore up all the carpet right before I left on Wednesday. Tonight: removing trim that wasnโt destroyed by water and installing flooring.
Sending love and support to everyone affected by this round of Twitter absurdity. Abrupt upending of your lives because the leader decided to flip the chessboard is cruel.
@skullface One benefit I didnโt realize until I got my watch is that it unlocks my phone so when I am wearing my mask I donโt have to take it off or type my code.
Troubleshooting ephemeral infrastructure is often a lot of โrequest system, wait for system to explode, read log, make one line change, repeat.โ
I know itโs been a busy day when AWS informs me there are no more instances to provision.
@WokenClick Iโm not sure thatโs due to mobile-first design. I think thatโs your classic high-school English tactic โincrease margin to stretch the appearance of a 1-page report.โ
@tenderlove You can use photogrammetry via your phone to get a fairly accurate 3D model and slice to 2D.
Alternatively, take a piece of paper, cut a hole for the shifter, then use a pencil and rub the edges of the shifter to get a relief. Then take a top-down photo with a ruler in the shot
Burst hose bib leaked water into my office wall. A whole lotta white noise in my office for a couple of days as industrial blowers and a dehumidifier drone on.
A week of staycation building out the basement with a Sunday bivalent booster resulted in yesterday being a foggy day ending in an almost 13 hour sleep.
@Esquiring Oooo that gets my noodle going. Iโve got a parametric model setup specifically for that, I wonder if I could hook up parameter change and mesh export to a scriptโฆ