/--/

[/--/ @DarthVader75583]

I feel like if I died today, I'd have amounted to nothing.

[/--/ @DarthVader75583]

Hi @FaibaJTL , I have been experiencing persistent 4G network drops and unstable speeds in Juja, Kiambu County over the last 24 hours. Please advise.

[/--/ @DarthVader75583]

If you do not understand the hardware reality, the software abstraction will eventually confuse you.

[/--/ @DarthVader75583]

When using the line tool in sketch mode (SOLIDWORKS) you can use the 'A' Key to switch between line and arc.

[/--/ @DarthVader75583]

An integer has exactly three positive factors if and only if it is the square of a prime number.

The factors of a prime number (p^2) are 1, p and p^2.

[/--/ @DarthVader75583]

just learnt how to dimension an arc in SOLIDWORKS :)

~ select the two end points of the arc and the arc itself.

I did not know that.

[/--/ @DarthVader75583]

factor x factor= multiple

0 is a multiple of every integer

[/--/ @DarthVader75583]

I am bad at this, and I need to learn the rules of why I am bad.

[/--/ @DarthVader75583]

a Tensor is to PyTorch what a cell is to Biology

[/--/ @DarthVader75583]

a number n can at most have one prime factor that is larger than sqrt(n)

[/--/ @DarthVader75583]

one can also set whole slots equal to each other.... I didn't know this.

I used to dimension them.

[/--/ @DarthVader75583]

The axis of revolution in the revolve feature in SOLIDWORKS need be linear.

Tried to use a curved axis and was unable to revolve my sketch.

[/--/ @DarthVader75583]

first time using "flip side to cut" in SOLIDWORKS...

I didn't know such a feature existed and honestly, it is a life saver.

[/--/ @DarthVader75583]

I didn't :(

But I will someday.

[/--/ @DarthVader75583]

I hope I manage to get the fees to pay for my GEC and MSC🧘. Nothing fancy, just enough to study comfortably🧘🧘🧘.

[/--/ @DarthVader75583]

I failed to get the correct volume when using the from offset in the Boss-Extrude feature :(

[/--/ @DarthVader75583]

>> precision instead :)

[/--/ @DarthVader75583]

85 -95 % accuracy on my models🧘

[/--/ @DarthVader75583]

I hope I manage to get the fees to pay for my GEC and MSC🧘. Nothing fancy, just enough to study comfortably🧘🧘🧘.

[/--/ @DarthVader75583]

85 -95 % accuracy on my models🧘

[/--/ @DarthVader75583]

@KenyaPower_Care There's been flickering lights in Juja JKUAT gate C areas...two days now..even after the long day of maintenance. Kindly fix this.

[/--/ @DarthVader75583]

I feel like if I died today, I'd have amounted to nothing.

[/--/ @DarthVader75583]

I honestly love my career path, I was born to do this..I just hope someday I get to have a job and fulfil my dreams.

[/--/ @DarthVader75583]

At this moment, I got nothing to look forward to...but I'm holding on.