Furry, pilot, mechanic, H/W engineer, BIOS/UEFI hacker, traveler, Ham, radio pirate. I fix stuff, cars, planes, specialized in Apple stuff. VAG MIB2/3 expert.
@GermanSkrat It's always the 3D printed stuff, horrible to wear. Just some pads of foam inside if you are lucky, so you keep recycling air in there. Foam heads only for me.
@PooltoyWolf These are just words, ignore. There is another "religion" you should worry about, they will throw you off the roof when they get the opportunity.
@pumpld Dont't want to rain on your parade but those nylon straps will cut into the latex in very short order. I don't see this lasting very long. Why not just glue the whole base of the tail to the suit? Base is big enough to hold up a tail that size.
@DogMutt71@robert_raccoon If I remember these were 3D prints? Strapping something hard plastic to my face for skiing would be a total nogo for obvious reasons. When made out of foam would consider, 600-800 range.
@wyooon2 I would hang the bucket on the porch there. Also drill some holes in it so it does fill up with rain, then hope she comes back. Dumb ass birds.....
@BurlyPowerMew You can get all the popular furs direct from China as that is where the US vendors are getting them. Should get cheaper even as there will be less demand from US buyers.
@Kimutiger I just do breakdown maintenance on items like this. I have a spare coil in the back of the car. A dead coil will not leave you stranded. Had 1 of mine die too couple of months ago, was a China one :(
@Kimutiger Problem is the ones you are going to buy are China junk and are even worse than the originals.....Using OEM then sure, but you don't want to pay that.