@JohnTerry85090 Sorry, I have also been busy and I'll remain so for a while yet.
I'll try to find time (and energy).
My summer vacation starts on the 15th of July and I don't have things planned for the first 3 weeks though. I could model stuff then, if the need isn't urgent that is?
@JohnTerry85090 You're probably right. This actually makes modeling it easier as the top slot is filled.
I'll adjust the model I got now and show what I mean.
Tomorrow?...
@JohnTerry85090 The clamps or whatever they are on the flanges will be cut as in the photos of the original.
I'm still wondering if the inner piece is a blank up and down och cut so it's the helmet plate we see under it reflecting light.
I can just model both variants to try.
@JohnTerry85090 Ok! Great. I have the model for it then. You also need the half moon piece on the inside to fasten it with an M4 screw and nut (or eq inch size)
(A shorter nut is recommended, this was the one I had a model of available)
@JohnTerry85090 I'll make a new black gadget thing for you as a single printable piece.
I had some issues with updating my Solidworks but it's fixed now.
I'll find the hose connector model for the lantern as well. It's a recessed collar.
@JohnTerry85090 Explain what part you mean exactly. I can model almost anything if I know what it is. :)
I have some parts I think are missing from the download pack. At least the hose connector for the upper back side hose to the lantern and maybe the inside support for the air coupling...
@JohnTerry85090 For the hose at the back I used this:
"CORRUGATED FLEXIBLE HOSE FISH POND PUMP MARINE PVC PIPE"
I think it was 12 mm / 0.5 inch diameter.
For the flex pipes on the sides I cut up an IKEA lamp but they don't sell tose anymore. I'll look for a substitute.
@JohnTerry85090 Yes I think the center section needs to be a bit wider than my model. The inner piece may also be protruding blocks on upper and lower and the X ribs are flat on the top.
The sheetmetal housing also looks like it has closed corners.
I'll model a new one, as a solid piece.
@JohnTerry85090 Yes it's a thin tiny thing. I can make the plate 50% thicker. It won't look quite screen accurate then but not by much.
My helmet parts are pretty nice but not 100% accurate anyway.
After 350 hours or so on modeling I later got actual close up photos of an original. One day...
@JohnTerry85090 I can just make you a smooth version and post as an alternative part on myminifactory.
It's a simple thing for me to remove the rotated multi cut in solidworks. A 1-minute work. :)