Co-Founder & CEO @ QMS2GO. Former API auditor (~250 facilities). I help manufacturers make quality visible: efficiency and evidence, not rip-and-replace.
I audited roughly 250 facilities as an API auditor. The best shops never had the thickest binders. Their daily work left the proof behind.
I post about audit readiness, CAPA, ISO 9001 and AS9100 in plain English. Ask me your hardest supplier-form question.
@LikeDolamite Moving the bottleneck is exactly it. When I was auditing, the inspection queue backed up long before the spindles did, and the paperwork trailed even further behind. Is the new lab going to sit next to the machines, or will parts still walk to a separate room?
@SMBAwningMan Keep the other 15 around, you'll want them later to see how far you came. Are you tacking both ends first or fighting the joint once the arc is on?
@vapor_ware404 a new facility means a new first article and a new set of gages. does the gen 2 shop run the same inspection plan as the original, or do you rebuild it from scratch?
@ChiefEngineerCE funny, i always judged shops by the machines with the maintenance logs on them. who built it matters less than who kept it running. what's yours?
@jv_madrid09 in audits the shops that do a start of shift huddle usually have fewer surprises with the revision on the print, because someone says out loud what changed. do you write down what changed on the print, or is it just verbal at the brief?
@JasonPremoMFG@Half_A_Pond small stuff like that is what people remember. does it show up in turnover numbers when the gifts get cut, or just in how people talk on the floor?
@GB_Drone@connorkapoor ha, that's a good way to put it. as an auditor I've seen the quality lead's measuring tools matter most when calibration records and gage ids are clean. a shop that can show traceability from tool to inspection record rarely gets surprised in an audit.
@hans_brunk the part that surprised me as an auditor was how rarely anyone tracked the hidden hours. shops knew the scrap cost but not the time spent segregating, re-inspecting and chasing paperwork. ask for the last nonconformance's full story and the real cost lived in people's memory.
Count the places your quality records live.
Inbox. Drive. Dropbox. SharePoint. Binders. One spreadsheet only Dave understands.
More than two, and nobody sees the whole picture. Including the auditor.
https://t.co/Xjg2N8DyXv
@jv_madrid09 shims are a sneaky one. in audits i see the same pattern: measured on the first piece, then trusted forever, no lot trace. cheap part, so nobody keeps a record, and then it's the first thing you can't prove when the stack up is off. how do you check flatness on the thin ones?
@scottastronaut@FlexMachTools flex arm is handy for tapping, no more fighting the drill press. do you torque check the first few holes or just trust it?
@jack_watson_hfw lost jobs and ones that went sideways usually trace back to what the quote assumed versus what the floor actually did. auditors always ask how estimating hands off to production. do you log what went awry per job, or just remember it?
@SMBAwningMan checking was smart. on the audit side, the real test is usually whether you can pull one specific record fast, not just whether the drawers are still there. is there an index for what's in those cabinets?