Finished making my Reaver Vandal which is the first cosplay prop I've made. Connected the trigger to my phone via Bluetooth to play sounds.
Thanks for the awesome model you sell @SaidaProps 🥳
@therealvintii @diagon16 Thanks Vintii! If I haven't gotten back to anyone, I apologize and thank you for reaching out. Doing my best and appreciate the support!
@Nicolas_Cptcbo The board should power on when it detects the power from the battery. Another thing to note is that once the switch is turned on the led strip takes about 5-10 seconds to turn on. The blue lights on the charger board should turn on immediately.
@Nicolas_Cptcbo The wiring looks correct! I would try leaving it plugged in with the switch on of course for a couple hours. Then if it doesn’t work out might need to swap the charger board. I know it’s annoying I sometimes get bad boards.
@Nicolas_Cptcbo Sorry I haven't had time to put the guide together yet. I printed the scope in clear resin, masked off the clear parts then sprayed filler primer over the whole thing. The LED strip sits in the center of the scope!
Primordial Jade Winged Spear #GenshinImpact this one is 6’ tall with 28 micro leds and 2x led noodles. 3d printed with Sirayatech craft clear and Polymaker CosPLA over telescoping Cf tubes for travel! Runs on two AAs and weighs roughly 3 lbs.