@InTheCenterLane @josefprusa Change your starting gcode in prusaslicer, you will see a line that mentions a firmware number just change that to a lower number than what you're using.
@themitch22 The only shoes other than my bad weather boots that have laces are my work shoes and I just find the happy just right medium in the laces and tie them once and just slip them on and off.
@strandjd @chrisriley3d @ChuckHellebuyck Spray the glass with a thin glue like hair spray and smash it down a lot closer than you would on PEI etc, it needs to be on the edge too close to get it right just on the edge of the extruder popping. But when you do it will be as smooth as the glass on the bottom of the part.
You stuck by me thru thick and thin the past three years since you came with the kit, thru petg and ASA and even a rash of flex, thru the great face shield run of 2020.. you held on and never let go.