DCN

[DCN @_dcnr_]

@F1Media This is got to be the single worst thing F1 has done for as Aussies. I don't want to pay exorbitant prices for Kayo. You are limiting the sports reach to a company that rate hikes every other week and it will make it impossible for younger fans to engage.

[DCN @_dcnr_]

@_boostedmedia @fanatec This might just push me to upgrade my 8Nm CSL DD to a CS DD.

[Fórmula Directa @FormulaDirecta]

🚨 Imagen de Pierre Gasly al volante del A526

#F1

[PolAvecesCompropeces @Pol_S]

Solo espero que esto se convierta en un meme como el del M8.

[The Race @wearetherace]

🚨 RACING BULLS ON TRACK!

Another day, another 2026 car breaks cover...

📸 Federico Basile Ph @ FB-PhotoImages

[DCN @_dcnr_]

@formularacers_ @Auto_Racer_it Fat airbox is very interesting

[DCN @_dcnr_]

@RBR_Daily @Auto_Racer_it That airbox is quite big... @dr_obbs

[DCN @_dcnr_]

@Qvist_Designs This is some proper footage https://t.co/rBBvNQX1pV

[DCN @_dcnr_]

@Qvist_Designs @cytrusf1 I figured out straight away with the wheel-brows on the front wheels.

[DCN @_dcnr_]

@dr_obbs Man does that sound good.

[Motorsport @Motorsport]

REPOST if Max Verstappen is your pick to win the F1 drivers' championship. 🏆🏆🏆🏆🏆

Just one race to go.

[DCN @_dcnr_]

@verstappenews Using weather as an excuse is beyond hillarious

[DCN @_dcnr_]

@fanatec Powered by CSL DD

[DCN @_dcnr_]

@getpeid @grok @grok pick me because I said so ;)

[DCN @_dcnr_]

@Qvist_Designs @jancikapral @TheBeevash No, not necessarily. By introducing the rake, you are effectively increasing the floor volume particularly at the diffuser, and if the floor is sealed well enough on the edges you are making your floor volume larger. Think of the RB16B.

[DCN @_dcnr_]

Total cost is looking around $650AUD ($430USD)

[DCN @_dcnr_]

I have decided to take a bit of a break from car modelling to shift my attention to a passion project of mines. I fully working DIY sim racing wheel that I can use on my sim rig. Details in the thread.

[DCN @_dcnr_]

WS2812B LED's will power the rev strip with 2 flag LED's flanking them. The mid-case is made of 3D printed PETG a long with the button surrounds, and encoder surrounds.

I will probably use a GX16 connector on the rear to drive this entire wheel with a single USB cable

[DCN @_dcnr_]

The display is a 4.3" VoCore display and the entire system (minus the display) will run off an Arduino Pro Micro via SimHub.

I am unsure as to what shifters I should use, but I am leaning to pickup the Fanatec Advanced Paddle Module with a Podium Module.

[DCN @_dcnr_]

I have not fully decided yet, but I plan on using either 5mm thick Carbon Fiber or Aluminium as the front and back panels.

I am utilising EC11 encoders along with momentary tactile push buttons with a white LED surround.