20” has never looked so small! About to process 28, 26 and 24 ga 36” and 24 ga 48” wide coils into a mix of sheets and smaller coils. Four coils totaling 14 miles. #redbudindustries#galvanizedsteel#galvanizedsheet
Our new Mechanical & Pipe Insulation Division is NOW OPEN in Doraville, GA. We are a full line stocking distributor of:
• Owens Corning Fiberglass, Mineral Wool, Foamglass, & XPS
• Aerocel and K-Flex Elastomeric Sheets, Rolls, and Piping
...and MUCH more!
Our Orlando branch buys a weekly Truckload of pre-made pallets for 4 x 10 and 5 x 10 sheets so it’s always good when we’re able to pick up the old ones when customers are finished with them. Here’s a picture of last week’s accumulation of old skids we picked up. #recycle#pine
One of our top selling machines has been this Norlock Clinching Machine. A huge time saver in shops on everything from “Square to Rounds” to this Duro Dyne Flex Connector assembly #clinching#ductwork#durodyneflexibleductconnector
Our Miami Branch has been effective at recycling our wood skids (picking them up after customer has used all the Galvanized sheets that were on them) #galvanizedsheet#pineskids#recycle
At any given time during the a weekday, we have dozens of trucks on the road across the Southeast like this one on I-20 West outside Tuscaloosa and heading to Jackson MS. #freightlinertrucks#conestogatrailer#greatdanetrailers
A lot of the 4x10 Galvanized Sheets that we sell goes to duct shops that are using them to cut out rectangular duct fittings on their Vicon Plasma Table. This shop is taking no chances with the smoke fumes: an exhaust duct under cutting bed (normal) and an additional one overhead
The 1/2” Hem Rolls can be ordered with closed or open hem. This Rollset requires 7 stations like on the Flagler HS7 High Speed 20 ga cap Pittsburgh mounted on the other side. Flagler is still 100% made in the USA, becoming rarer these days in sheet metal fabrication machinery
When Securing Liner to Duct Fittings like these, weld pins are placed in position and then an MF12 pinspotter is used to make the weld. Here is 2” K Flex elastomeric for a job at Orlando airport #sheetmetalcontractors#ductliner#elastomeric#ductflow
22 ga Galvanized Perforated is the standard for the inner wall of Double Wall Duct. 60” wide sheet and coil is indicative of DW Rectangular just as 5.394” is of DW Round. #doublewallduct#perforatedmetal#soundattenuation