d3smo

I moved to BlueSky

[d3smo @d3smo]

#Monoflex is milmaxed, I build it tomorrow live on Twitch https://t.co/WlXcADhyKz

[d3smo @d3smo]

60% case project in #3dprint i've in mind

[d3smo @d3smo]

The PoorCable we've built on stream today, and that will be a great accessory with the #PoorKoi, check the reveal video BTW https://t.co/lP66Q9jMP4

[Paris 2024 @Paris2024]

Pas mal nan ? C'est français 🇫🇷 #Paris2024

[d3smo @d3smo]

Tomorrow we will make a PoorCable on stream with these parts https://t.co/WlXcADh0V1

[Nokia for Service Providers @nokianetworks]

Nokia has achieved a huge milestone – the world's first full duplex transmission for wireless backhaul/fronthaul!

This technology allows for simultaneous transmission and reception of signals over a single channel, doubling the network capacity.

https://t.co/NW8i2thTxM

[d3smo @d3smo]

Designing and printing some goodies for next meetup <3 our community

[d3smo @d3smo]

Today I've shipped the cute cable done on stream Saturday, thx @faitsatif for the pro looked sticker

[d3smo @d3smo]

Here is the cute custom cable we build on stream yesterday, replay available on my YT channel https://t.co/8PUl7ZC4nN

[d3smo @d3smo]

d3smo
Stream setup ready, live in 5min

[d3smo @d3smo]

Tomorrow i'll build in stream a custom cable for this amazing keeb build by @t_tkeeb some weeks ago https://t.co/WlXcADhyKz

[d3smo @d3smo]

Fractal Design Project: North Pi: Raspberry-Pi-Gehäuse im ikonischen Design steht zum 3D-Druck bereit https://t.co/AGB46gKPz2 #fractaldesign via @ComputerBase

[d3smo @d3smo]

Thx #3Dprinting for fast prototyping

[d3smo @d3smo]

Still improving stream material, with an homemade phone support for close shoot webcam #DiY #3Dprinting

[d3smo @d3smo]

I've been clipped for the first time, first big step in a streamer life https://t.co/QExFXz8CIe

[d3smo @d3smo]

#FEMO 1B was not hard enough let get some challenge with 0B, I've plan to stream it on 27th, subscribe to be part of it https://t.co/WlXcADhyKz

[d3smo @d3smo]

My #Rookey macropad is set up for next #stream @takashicompany @pcbway https://t.co/WlXcADh0V1

[d3smo @d3smo]

@takashicompany @PCBWayOfficial Sure and do not hesitate to ask me if you need detail on the assembly.

[d3smo @d3smo]

@takashicompany @PCBWayOfficial I've shared the 3D files of the case i've made for the gasket mount #Rookey check them on ThinGiverse https://t.co/SoXeTGo3Oj and feel free to share to the world

[d3smo @d3smo]

#rookey Gasket Mount done @takashicompany
@pcbway