⚠️ ~85% of 3D printers marketed for high performance polymers can’t reliably print PEEK, 77% fall short for ULTEM 1010, and nearly half can't reach the required temps to print ULTEM 9085.
Learn more 👉 https://t.co/qIAssw1FY8
#additivemanufacturing#3dprinting#3dprinters
Life update: As you saw in my recent repost, I'm working now at https://t.co/EdsPSsdYqS as COO, and I've moved to Montreal. A bit more detail on FB or LinkedIn if you follow me there.
🔥 Print 54% Faster — Without Sacrificing Quality 🔥
AON3D’s new software uses physics to dynamically adjust print speeds based on part geometry and each polymer’s thermal and flow behavior.
👉 https://t.co/lMIb7s7OKR 👈
#3dprinters#3dprinter#3dprinting#materialscience
I'm in Florida, and I'm getting served ads to vote for Rubio, but the ads link through to American Energy Interaction. Very fishy. #Florida#flapol#floridapolitics@politico https://t.co/eZnwFUL9wB
Two years working for #adphi will get you a lot of states. Especially if you decide to drive to the West Coast. Now I need a Canadian province version of this map. . . https://t.co/Wd33zmcwLP