John

PrototypeModeler/PaintChef/Designer

[John @kimpod]

@snkr_twitr 10

[John @kimpod]

@AlexPlusLEDs Is that with the flexible board?

[John @kimpod]

@LeahLovesHomes @elonmusk Yes trade-ins are welcome!

[John @kimpod]

@AlexPlusLEDs makes sense... was gonna say... *eyebrows were raised*

[John @kimpod]

@AlexPlusLEDS are u serious?

[John @kimpod]

@AlexPlusLEDs here

[John @kimpod]

@HiddenCash ... going to a titty bar?

[John @kimpod]

@HiddenCash... going to a strip club?

[John @kimpod]

@AlexPlusLEDs... who are you asking?

[John @kimpod]

@AlexPlusLEDs here it is finally!!!

[John @kimpod]

@AlexPlusLEDs it could be the lack of side panels around platen (helps envelop/retain heat in the print area) or moisture in the filament.

[John @kimpod]

@AlexPlusLEDs @kimpod

[John @kimpod]

@AlexPlusLEDs reduced platen temp can cause that.

[John @kimpod]

@AlexPlusLEDs... no image

[John @kimpod]

@AlexPlusLEDs dang

[John @kimpod]

@AlexPlusLEDs... gauntlet.

[John @kimpod]

@AlexPlusLEDs describe this one.

[John @kimpod]

@AlexPlusLEDs !!!!!!

[John @kimpod]

@AlexPlusLEDs with blue tooth!... tell me how to shoot the money over to you.