We are currently training new staff in areas which need additional support and will allow us to improve manufacturing, production, and provide all of you continued updates on the status of your molds.
@DiceWitchery @CritCastResin The demold time at room temperature is not 2.5 hours. Itโs more like 6-8 hours. If you heat it, you can get it down to 4ish, but too much heat will cause any epoxy to shrink. It is quite thin, so take that into consideration when you pour.
@StarsCassiopeia Vacuum chamber is super helpful for higher viscosity silicones, but certainly not required. A pressure pot, on the other hand, is critical for good results with resin and silicone. Avoid the HF pot and get one by California Air Tools or Vevor ๐
@joan_d_snark @WitchDoctorDice Definitely different from standard epoxy. Weโve poured something like 4 gallons of the stuff for dice and it sets up hard, quick, and has very low shrink. Certainly worth trying.
@Faudwyn Hopefully soon, but I donโt have an exact date yet. The last two months have been an absolute hell of trying to get raw materials from our suppliers and scaling for production ๐
@GoofyGopher323 @thetinyGM Hopefully soon, but weโve been fighting with supplier delays on our kickstarter fulfillment. Thatโs pushed everything back