Malte

@malx_14

Deutschland

Joined December 2017

93 Following

37 Followers

4 Posts

Malte @malx_14

over 4 years ago

A geared motor is used which drives two belts on the left and right to which the Z-carriages are attached. A fine adjustment mechanism for aligning the carriages is missing. I hope that this isn't a problem and that the alignment via the rotation of the pulley is enough. 2/2

malx_14's tweet photo. A geared motor is used which drives two belts on the left and right to which the Z-carriages are attached. A fine adjustment mechanism for aligning the carriages is missing. I hope that this isn't a problem and that the alignment via the rotation of the pulley is enough. 2/2 https://t.co/BnAwboBLr6

Malte @malx_14

over 4 years ago

I started to build the Xprinter V2. The drive system for the Z-axis is looking good. The cheap mgn7-rails have quite a lot of play which could be a problem. designed with @Freecad and #LinkStage3. #3Dprinter https://t.co/pCjh3LStjy 1/2

malx_14's tweet photo. I started to build the Xprinter V2. The drive system for the Z-axis is looking good. The cheap mgn7-rails have quite a lot of play which could be a problem.
designed with @Freecad and #LinkStage3. #3Dprinter https://t.co/pCjh3LStjy 1/2 https://t.co/7WfsLTAFt3

Malte @malx_14

over 4 years ago

@kaangoksal @FreeCADNews @hackdayio I used assembly4 workbench, but mainly arranged the parts by using the placement paramters

Malte @malx_14

over 4 years ago

I'm in the final design stages of the second version of the Xprinter. This time modeled with @FreeCADNews and #LinkStage3 I'll write about it on the @hackdayio project page: https://t.co/pCjh3LStjy + post updates of the build-process here on Twitter