Finally found out where the term 'sprite' comes from: "I invented this thing which I called 'pixies' but it turned out 'pixies' was trademarked, so we changed the name to 'sprites'." https://t.co/UseVxotznW
@matseng Woah the whole top of the connector is GND or Vcc? Haven't seen that before. Usually with arcade PCBs a soldered connector is because a previous operator or owner soldered wires directly to it. Good luck with the solder braid.
@matseng Related, yes. 'TV Typewriter' is from the PONG era in my mind (early '70s), while 'Cheap Video' is close to how a Sinclair ZX80 works and more interesting to me. 'Son of Cheap Video' I liked less. There's also a TV Typewriter 2, not sure if it's a book or just articles.
@Devilish_Design That image is so close to being readable too.
At worst you could use a process of elimination, making sure outputs go to inputs etc. Quite a puzzle.
@matseng I've also ordered an audible milliohm meter kit from ELV: https://t.co/BAQi8fpNAJ
Perhaps that one will tick all the boxes, should arrive this week.
@matseng I was just looking into that a few days ago. Found a good list of circuits: https://t.co/Xpg85M3QQX
I plan to build the 'ultimate' one, doesn't even need an on-off switch (I don't think the red comment is true).
@MartinPiper Cap & resistor (I think a diode too) with LS14 to clean it up. Commodore used a 555 but that's a mess. Atari had a neat circuit to also let power stabilize and reset the CPU if it got stuck on arcade games.
@matseng Cool, you got it cheap. I considered bidding on it but I don't have a Windows machine. Also I read that TL866 can burn 2716 if you get set the pulse width, haven't tried yet: https://t.co/FO9VlBX9u3
Here is an almost never told story… in the L shaped strip mall that had Computerland at one end, there was a small print shop near the other end. I had the original cover sheet and manuals printed there, which my mom and I stapled together at home at the kitchen table.
When they were being printed, it was just me, and the young woman on the other side of the counter running the huge printing press. The printing press had ink, that was spread evenly before being transferred to the final roller with the image on it, by running over a series of rollers rolling in opposite directions… perhaps 6 such rollers.
While the woman was operating the press, making the Akalabeth manuals, her hair got caught in the rapidly spinning series of inked rollers! In a matter of a split second, it sucked in her long hair, and slammed her cheek into the machine. Fortunately, she also, instinctively, reached around and shut off the machine.
But, she was now pinned against the machine, deeply entangled and bleeding significantly.
I jumped over the counter and began disassembling the machine in haste. By the time we got her “extracted”, we where both covered in ink and blood. So was the print shop. But we did get her out, a few stitches were needed to patch her up.
So… if you have an original Akalabeth… check it for blood and hair!
;)
Richard
Shooting Saucer is out now on steam!
run away from a flying saucer chasing you around the solar system, defeating bosses and finding new playable buddies along the way