pointfair

[pointfair @pointfair]

@dpoddolphinpro @KSpaceAcademy @NASASpaceflight You can see it slows down a tiny bit before impact on the water. Great work, I wonder if SpaceX did something similar or did they also have cameras around the landing area?

[pointfair @pointfair]

@thejackbeyer Scrub again?

[pointfair @pointfair]

@TheLightSpeedz I got 1 Prusa XL5T and it prints great for me. Had some minor issue's in the beginning but all of those where sorted with help of Prusa Customer support.

[pointfair @pointfair]

@ac2020 @gunsnrosesgirl3 Extra flavour

[pointfair @pointfair]

@Worldwar_3_ Finally the circle is complete. It started with the Cuba crisis and it will probably end there.

[pointfair @pointfair]

@reprinted3D @Prusa3D @PrintedSolid I had to do that once (luckily) when my Mini was not able to print properly (even after all the suggestions by Prusa). For the Mini it wasn't too bad to disassemble and making pictures for every packaging step. But i hope my XL will stay healthy because of that.

[pointfair @pointfair]

@lopatonok @PeteHegseth He didn't stopped any war.. he will start the ultimate one.

[pointfair @pointfair]

@DD_Geopolitics Soon.. very soon now.

[pointfair @pointfair]

@elonmusk Untill he shutdown certain parts of the network, like in Febr. 2022 to intentionally cut off Ukrainian to prevent the counteroffensive in the Kershon region. He can do what he likes.

[pointfair @pointfair]

@InternetH0F A little bit excessive in my opinion. Closing door, check if door handle is flush and vent door closed and flush to door structure doenst need hands on. Visually check every thing is enough. If not closed properly door sensors will alert flightdeck crew with a warning.

[pointfair @pointfair]

@reprinted3D @josef If, and i hope things get sorted out, you are going to box it... also good luck (depending if you had had a kit version) to put it in the same Prusa box(es) again. I had to do that once for my Mini.. and that was a struggle.

[pointfair @pointfair]

@UncleJessy4Real Been there, done that. Luckily they didn't find anything in the 3 removed polyps.

[pointfair @pointfair]

@AMAZlNGNATURE Just sleeping.

[pointfair @pointfair]

@thejackbeyer @NASASpaceflight Well... no moon for some time then.

[pointfair @pointfair]

@CanuckCreator @Prusa3D And i assume you ignore the temperature difference warning between the 2 filaments?

[pointfair @pointfair]

@agepbiz @Prusa3D I asked Prusa customer service for when they bring more control and video recording to the Buddy3D cam. He said that they working on it.... but it's been months since that question. Not using the camera since i got it.

[pointfair @pointfair]

@dpoddolphinpro Too soon... 😉

[pointfair @pointfair]

@dwisecinema @NASASpaceflight No flight soon then.

[pointfair @pointfair]

@reprinted3D @Prusa3D It seems you are very unlucky with your XL. Mine works perfectly so far. I had some minor issues but those where resolved after help from Prusa support.

[pointfair @pointfair]

@Joe__Bassey Might....?