Presenting: The #HashTub Defroster, an Antminer S9 with an Ethernet-Cellular Router, produces 1200W of heat from any 120V outlet.
Basically the Hashtub completely froze with the 10F/-12C temps over night, and using the S9 is the easiest and most efficient way to defrost it :)
@Fuckleberry90 A bag sealer is most likely, but it could also be for heat bending sheets of acrylic, although in that case you would expect it to be mounted on a jig of some type. https://t.co/IZO5EVqnO2
@jamesrambin Schlotzsky's pretty well represents the new Austin I think. Remember when the one on S. Lamar had those transparent bodied gumdrop Mac's, and you could use the internet there ?
@Applied_Ion If it's hard to step back a bit, the book exercise can give you a mental closure. It also leaves a staring point for someone in the future. I will buy two copies (one for me, one for a Hackerspace library). Use leanpub, price it more than $100.
@themitch22 Go to https://t.co/A2nosmjCzv and craigslist -> office/commerical and search on "shop space". Also drive through industrial areas near you and call the numbers on the property management sign. Tell them what you do, some have restrictions like no auto/no woodshop.
@nmdmatt Well said. A framework for collaboration that is not a corporation with stock is the whole promise of it IHMO. NFT's and similar are just test scenarios for what will be the real use, like learning poker with chips before going to real money.
@laurenweinstein It's the front axle of an older car or truck. The horizontal tapered spindle is where you put the bearing and wheel. You know it's the front axle because the vertical hinge let's it turn, and you can see a grease fitting at the bottom. https://t.co/lt0mY0EILF
Request to all my friends on twitter - make some noise and get twitter and twitter support tagged to overturn the ban on @filastruder's account. It's a bogus claim and needs overturned!
@techknight2 First try ignoring the 1.2mm diminsion in searches, get one wider and trim it. Second option is to find someone to 3D print it out of TPU like https://t.co/vI8i6prWB1 but with no teeth. Again you might find it best to print it taller than needed and trim it with a razor blade.