Stirling Moll

[Stirling Moll @Stirls308]

For anyone interested our annual field day is tomorrow morning.

[Stirling Moll @Stirls308]

@GribbleRC @NewHollandAG @harvestaire_pty @blowy_moll

[Stirling Moll @Stirls308]

@GribbleRC @NewHollandAG @harvestaire_pty Was at the harvester workshop at Culcarin last week, have the 9.90 with S cube rotors, don't believe I'm having and rotor loss issues but would I see any other improvements with this mod since my rotors run the vanes in this area? Keen to give it a try otherwise

[Stirling Moll @Stirls308]

@KLIMPSCHY12 @danking265 @blowy_moll There are easier ways to replace the rotary valve rubbers

[Stirling Moll @Stirls308]

@GoddeAndrew @blowy_moll @CaptainCanola @pioneerseedsau @NuseedAustralia 2 wires out 1 in when your get your header undies, 950-1000 rotor rpm 23mm concave it will shoot it through

[Harrison Schenck @FractionalList]

How to destroy a society,

- Make art ugly
- Make porn free
- Make God a joke
- Make food poison
- Make Dads optional
- Make politicians rich
- Make money worthless
- Make buildings oppressive
- Make men and women compete
- Make children hate their ancestors

What’d I miss?

[Stirling Moll @Stirls308]

@Billwal09406387 I've got no advice as far as the wheel motors go but at least you'll know where not to drive the header..

[Stirling Moll @Stirls308]

Has anyone had a yield sensor problem with a late model new Holland .90 header? If so what was the outcome?

[Stirling Moll @Stirls308]

@snides007 Phil’s Custom steel in Jindera has drawings and can make them

[Stirling Moll @Stirls308]

@sameagle6 @pearse_kyle @Billb95012353 Try the RFM spring coil gauge wheels, I tried a couple this year and you can’t stop them in any conditions,

[Stirling Moll @Stirls308]

Does anyone have settings they use on a current Vicon Isobus spreader for spreading Metarex @ 4kg/ha? App tells me I can do it if I drive at 362.1 km/h @36m, that’s not going to happen today, thanks in advance. #probablyshouldofstayedwithamazone

[Stirling Moll @Stirls308]

@sameagle6 Also what scrapers are you running? The new longer ones that go right to the hub have been a lot better I’ve found.

[Stirling Moll @Stirls308]

@sameagle6 Have the scraper as close as you can, backing the boot off from the disc a little bit and readjusting the scraper is the go, make sure the boot is tight though on the adjusters and pull up mid run to make sure seed placement is still ok after adjusting boot.

[Stirling Moll @Stirls308]

@Vikkysmart01 @terex444 Samsung is for fridges