@Malic_VR And I will finally note because I ran out of characters that if you are very patient you can also swap the pins with a paperclip. Put the pin on the new wire. And reinsert. But it is dreadfully easier to use the tool
@Malic_VR you can use a jst pin tool to pop the pins out and reuse it. Since the connector itself doesn't look damaged in that pic. When I make them for my drones I usually start with fresh ones. If you have a 3d printer with a 0.2 nozzle, Ive successfully printed one or two in a pinch.
Do you have any stands with the 3 bolt pattern for the new pro wheel from logi yet? I'm using an old stand for my g29 that I don't think has enough structure for the pro wheel. @nextlvlracing
Uhh,
MultiVersus
Satisfactory
Star Citizen
DemonCrawl
Rocket League
I read and responded to the original tweet.
Never realized I was listed in it hahahahaha.
I would nominate some friends, (turnerIfIHadOne/Anymeme.jpg)
@vkbsim@RobertsSpaceInd@BuzZz_Killer I have plates incoming to adapt my mounts so I can increase the tension on the dry clutches just a bit. But yeah, I had a friend grab just a left Omni to go with his Delta and he also immediately had more control over his ship.