Taste The Code

Software developer with a YouTube channel. I make videos about electronics, coding and general DIY projects.

[Taste The Code @taste_the_code]

Tasmota + HC-SR04 + NodeMCU = a pellet level sensor that finally works the way I want it to.

https://t.co/qkraVaVLx4

#Tasmota #ESP8266 #IoT #MQTT #TasteTheCode

[Taste The Code @taste_the_code]

Free PLC firmware for your Arduino or ESP32 using OpenPLC and real ladder logic.

https://t.co/EY2g339z4b

#OpenPLC #LadderLogic #Arduino #PLCProgramming #TasteTheCode #PLC #IndustrialAutomation

[Taste The Code @taste_the_code]

A 40W diode laser cut clean through copper on the first try. Full Longer B1 review plus a DIY bench PSU build.

https://t.co/dBww099zac

#LongerB1 #DiodeLaser #CopperEtching #DIYElectronics #LaserCutting #TasteTheCode

[Taste The Code @taste_the_code]

Tore open a disposable device and found a working 850mAh battery + USB-C charging board inside.

https://t.co/SSx96uF5ou

#electronics #DIY #lithiumbattery #PCB #batterycharger #TasteTheCode

[Taste The Code @taste_the_code]

A budget digital microscope that shows bond wires inside a 0603 LED. Full PCB inspection test here.

https://t.co/8qcXGK0dyY

#DigitalMicroscope #PCBInspection #SMDSoldering #Electronics #TasteTheCode

[Taste The Code @taste_the_code]

4-channel 18650 tester measures capacity and internal resistance on each cell independently.

https://t.co/6Q8IfADJfU

#BatteryTester #LithiumBattery #DIYElectronics #MakerProject #TasteTheCode

[Taste The Code @taste_the_code]

A solder bridge was shorting the right audio channel to ground on this 80s boombox.

https://t.co/4Cg4Ip0IYs

#BoomboxRepair #VintageAudio #TasteTheCode #electronics #repair #boombox

[Taste The Code @taste_the_code]

Electrical noise ruining your power switch? An optocoupler fixes that by fully isolating both circuits.

https://t.co/BsZacgNF0C

#electronics #optocoupler #PCBdesign

[Taste The Code @taste_the_code]

I tried to repair a plasma ball...

https://t.co/VNPTXuFrzk

#repair #plasma #Transistor #electronics #plasmaball #dıy

[Taste The Code @taste_the_code]

Use UWB for indoor asset tracking with this easy kit!

https://t.co/Q7iGuQgsLb

#UWB #IndoorTracking #AssetTracking #electronics #reyax #diy #tracking #automation

[Taste The Code @taste_the_code]

Learn how you can add touch control to your projects wit TTP223 module or using ESP32 touch capabilities!

https://t.co/d3cJikLETA

#touch #TTP223 #ESP32 #electronics #arduino #diy #touchcontrol

[Taste The Code @taste_the_code]

You can easily upgrade your devices to use USB-C for charging!

https://t.co/8VEglWu4Xy

#repair #portreplacement #USBC #electronics #usb #diy #upgrade

[Taste The Code @taste_the_code]

I built adapters for my tool batteries to convert them into USB PW sources to make an adjustable power supply with the PocketPD power supply!

https://t.co/ILgprvcNaq

#pocketpd #PPS #USBPD #powersupply #USB #electronics #diy #toolbatteries #battery #usbc

[Taste The Code @taste_the_code]

We played hide and seek with my friend to figure out how good Meshtastic is for GPS tracking!

https://t.co/izUbL0GcgY

#Meshtastic #GPS #tracking #LoRa #OffGrid #Heltec #N39 #DIY #Emergency #PCBWay #TechReview #OpenSource

[Taste The Code @taste_the_code]

I tested the nRF24L01 communication range in real-world scenario with some surprising results!

https://t.co/2gYl0yMuBv

#nrf24l01 #rangetest #electronics #wireless #arduino #nodemcu #esp32 #esp8266 #project #test

[Taste The Code @taste_the_code]

Real-time relay control over LoRaWAN with a Class C end node!

https://t.co/qb3UutUZPf

#LoRaWAN #Relay #IoT #ESP32 #electronics #arduino #smarthome #diy #project

[Taste The Code @taste_the_code]

I build a smart keypad-controlled access system using an ESP32 and components from the EEmentor IoT Starter Kit!

https://t.co/p664cEq0BD

#ESP32 #ESP32Project #AccessControl #keypad #electronics #diy #IoT

[Taste The Code @taste_the_code]

After my AC's Wi-Fi died, I built a simple ESPHome device to control it with Home Assistant again using infrared!

https://t.co/a503c2p2m8

#irremote #esphome #HomeAssistant #smarthome #climatecontrol #electronics #irblaster #remote #esp01

[Taste The Code @taste_the_code]

Learn how you can make a Class A LoRaWAN sensor node that sends temperature, humidity and atmospheric pressure to TTN.

https://t.co/D5r384NK35

#LoRaWAN #LoRa #TTN #sensor #BME680 #IoT #electronics #diy #automation #arduino #esp32 #esp8266

[Taste The Code @taste_the_code]

I built a simple LoRaWAN end node to test the availability and range of a gateway!

https://t.co/Eaxc7qxNDV

#LoRaWAN #Gateway #test #meshnology #arduino #lora #iot #electronics