wireengineer

I like assembly (both types)

[wireengineer @wireengineer]

@Runicmajier https://t.co/Gr2L9tfNkT

[wireengineer @wireengineer]

That feeling when you realize you have been doing dinner and anime with the group every week for more than a decade....

[wireengineer @wireengineer]

@RobertDaleSmith Yep working on encoders now

[wireengineer @wireengineer]

found something

[wireengineer @wireengineer]

Encoder is working but it does not show up on boot. Needs a hotplug to be detected for some reason. Good enough to start taking bus traces and emulating.

[wireengineer @wireengineer]

Things afoot

[wireengineer @wireengineer]

When you know from the factory it will not start....

[wireengineer @wireengineer]

And it's off the trailer. Let the cleaning begin

[wireengineer @wireengineer]

And done for the day

[wireengineer @wireengineer]

Believe it or not that was my first guess at center of gravity

[wireengineer @wireengineer]

@SecureThisNow @Hyr0n1 Ooo where are they at... Have a need....

[wireengineer @wireengineer]

Controls unwired and cabinet removed. Just the quill to remove before I have to get back into sketchy stuff.

[wireengineer @wireengineer]

Started disconnecting the control cabinet

[wireengineer @wireengineer]

@KirkMattwood Hopefully. will be a while before it runs. Just trying to break it down enough to get off the trailer

[wireengineer @wireengineer]

Off to make questionable decisions

[wireengineer @wireengineer]

Correction very. But ways look good

[wireengineer @wireengineer]

Sketchy not sketchy

[wireengineer @wireengineer]

Y reassembled and adjusted. Just need to figure out scale mounting and lock screws

[wireengineer @wireengineer]

Table back on and y lead screw thrust bearings adjusted. Need to do the gib and rear bearing mount yet