@CosmicChains500 Personally I like useing a grease needle on my grease gun to pump the grease right into the bearing. However in that video, this look like drive axels that would have gear oil lubrication not grease
@ElectronixPurge That sounds like a cam or main bearing starting to spin. It wont go long before it locks up completely. On the flip side at very least a head is toast, if its a main then the crank and possibly the block are toast. That sucks. Have you had any oil issues with that engine?
@303SnowWolf I could be wrong, I'm on the east coast and never submitted for the approval in That air space. But I checked and I believe you can Request Laanc approval up to 400 feet at the con hotel site. You would need a part 107 and prior approval from faa for date and altitude.
@burkebythelake Part of it is supply and demand. As gas prices increase less people drive. They work from home, limit travel, car pool etc. However Trucks still need to haul goods, Heavy equipment still needs to run, etc. So the demand for gas goes down, but the demand for diesel stays
@ElectronixPurge Chance that the dash cluster was replaced and the fire suppression emblem is over a different bulb? Did this in my obs ford. New cluster has air bag emblem where the alternator emblem used to be. Was trying to figure out why a truck with no airbags had a airbag light on
@Spottyroo I converted a r12 system to r134 in a freightliner truck. I swear it was blowing low teens. Could see you're breath in the cab of that truck. The modern systems dont seem to work that good
@DirtypawsHusky I believe you can use acetone in a sealed chamber with certain printable plastics to smooth the surface, however it's a art form as to much will weaken the plastics