zzattack

[zzattack @zzattack]

@audiolympics Pioline for Tsonga and I'll agree

[zzattack @zzattack]

@VeeSTARWilliams "so surprised she's not #1 in the world" was brutal

[zzattack @zzattack]

@RazOlsRF volley?

[zzattack @zzattack]

@MehdiHacks @Spacecolonize I've been using a dental xray for pcb inspection. The fov of maybe 25x25mm is quite limiting and larger chips require stitching which is annoying but workable.

[zzattack @zzattack]

@qwertymodo @jeffqchen try working with Altium defaults... I never touch it anymore in favor of kicad. Money well wasted.

[zzattack @zzattack]

@obnoxiousMods 👊

[zzattack @zzattack]

@XaraVFX congrat

[zzattack @zzattack]

@obnoxiousMods @sthetixofficial they're mu's

[zzattack @zzattack]

@sthetixofficial @obnoxiousMods I'm guessing from my handwriting it's uH. Measurements could be off, they were done by LCR tweezers and it was quite tedious so definitely not perfect. you can typically deduce the exact component from reference schematics of the surrounding ic

[zzattack @zzattack]

@sthetixofficial @obnoxiousMods any passive component with similar or near primary property will be totally fine

[zzattack @zzattack]

@Slot1Gamer @modzvilleusa no, ordering instructions are in the github. you can have 5 made for 2 usd

[zzattack @zzattack]

@AlanSilvey @sthetixofficial see https://t.co/RKoxrKfMke for pics

[zzattack @zzattack]

@RetroRandRs look at the "rev 1.6 128MB ram upgrade". you can stack a new RAM chip on top of any of the other 3 and use only the /CE from its dedicated line

[zzattack @zzattack]

@Trineas_ @PurpleRTA they were nicely modified too, by arcademaster1 iirc

[zzattack @zzattack]

@tom_verbeure @makerprobe thin layer does the trick, apply with cheap brush
https://t.co/DJhcQ6Htqj - alternatively heat with IR first (but always reheat with hot air)

[zzattack @zzattack]

@borti4938 can both C8G and I7G speed grades of the fpga be used?

[zzattack @zzattack]

@Jcmejiaus @sthetixofficial heat up a corner for a few seconds to soften the glue; after that it pulls up easily with fine tweezers and once you have the first part going you can tug on that for a very simple removal

[zzattack @zzattack]

@muzammi70148675 according to my notes it is a 47k resistor, looks like 0201 package

[zzattack @zzattack]

@DutchjRTA @Awesomocity0 congrats brother. 🤞he grows fast and gets to go home soon! and speedy recovery to his mom. did you pick a name?