Adam

Opifex

[Adam @Adam0x59]

My catapult creation, fully 3D printed, prints flat to fit in a C5 envelope.

[Adam @Adam0x59]

@BambulabGlobal @adafruit In 2020, so carefree... What supports? Why worry? Mine is just a cat toy... Well done for bringing soluble support to more makers, I may try it one day!

[Adam @Adam0x59]

@josefprusa @adnarimnavi Can confirm - PETG-CF and Lipstick Red PLA.

[Adam @Adam0x59]

Voroni cones by @davemakesstuff (PETG-CF), for @headamame headphones! - https://t.co/UpjvqfDLG7

[Adam @Adam0x59]

Tool depth issue is of my creation, model is good!

[Adam @Adam0x59]

Not fully assembled yet. Tool dies need work, too deep. Nice design, fun print! - https://t.co/ASgY8ZRNE6

[Adam @Adam0x59]

PETG-CF with PLA support - Reduce contact z distance; some minor warp issues.

[Adam @Adam0x59]

Pulleys, @Prusament PETG-CF and Lipstick Red PLA. - https://t.co/05CbByvwiv

[Adam @Adam0x59]

Red in the printer, why not! https://t.co/LRAE8VaUNQ

[Adam @Adam0x59]

Yesterday's print, free moving hexagonal rings connect each tile! https://t.co/6TBAvzLjHN

[Adam @Adam0x59]

@Construct3D_AM @ElectroBOOMGuy Someone broke into my workshop once, took one of these... Value to weight, a confusing choice, They left the fancy saw that plugged into it and weighed far less, maybe the handle swayed their choice...

[Adam @Adam0x59]

One day they will find a bottle... https://t.co/lzbFFT1T9i

[Adam @Adam0x59]

@themitch22 @devmobnow Exactly, it's the 2D stuff where you just want to set feeds and speeds and say, follow this line from here to here at this depth... Templates seemed like the solution, but I still review all the settings. I trust its judgement far less on simple jobs than seems reasonable.

[Adam @Adam0x59]

@devmobnow @themitch22 Fusion360, it's a lot of work. When the first job is surfacing the spoil board, and you're trying subtractive CAM for the first time. Well it's a steep hill to climb, more like a wall... I very nearly switched, but I quite like it now.

[Adam @Adam0x59]

@PaintYourDragon A temporary repair... 422 days and still going, the replacement pulley was printed in PC-CF. I should really replace it with a metal part but it's become a test of endurance...