BES Plumbing

Always looking to progress and gain further experience in the Plumbing & Heating industry.

[BES Plumbing @PlumbingBES]

@Bigleekplumbing Great. Don't suppose you have used it at all? Have hot to be a sprayer to get a good finish do you 🤣

[BES Plumbing @PlumbingBES]

Anyone know of a filler available for acrylic bathrooms? Couple of nics in my own and would like to fill them if poss. They aren't serious enough to need a new bath. Thanks

[BES Plumbing @PlumbingBES]

Any retweets appreciated. Looking to link up with someone for more/regular work in possible. Very keen to keep learning and my work up to now is of a good standard i feel. Reliable, drive etc... and have most tools required. Would like to gain my gas as well. Based near Wigan.

[BES Plumbing @PlumbingBES]

@Bigleekplumbing Although the molding of this @IdealStandardUK bath its terrible

[BES Plumbing @PlumbingBES]

@Bigleekplumbing Going to be tiling this. Can't be doing with those plastic panels

[BES Plumbing @PlumbingBES]

@robwilson0588 @alexxweller @AndrewGoldson1 @FrontlinePlumb1 @Ian_Vaillant @Plymouthgas @jarvisplumbing What level is this?

[BES Plumbing @PlumbingBES]

@AntParkes Sorry Ant when i say brick i just mean how the tiles are on the wall. These are the tiles they are large 12x24 but just wondering whether to start on the bath so they are running on each wall then

[BES Plumbing @PlumbingBES]

Any advice appreciated. Full bathroom to tile. Tiling in the brick affect so is best to start tiling on the bath wall itselfs so that i can use that to line up the other walls? Thanks

[BES Plumbing @PlumbingBES]

@koolhandedkid @FixRadioUK @UK_CW Amazing

[BES Plumbing @PlumbingBES]

Full bathroom refit and the only issue the pricey waste on bath wouldn't nip up to seal. Whack on @vivasanitary job done 👌🏻

[BES Plumbing @PlumbingBES]

@Installermag @Fernox Off subject sorry but could have removed that excess flux 😬

[BES Plumbing @PlumbingBES]

Any tilers give a bit of advice. Looking to do the bathroom in the same tiles. In the past I've been give diff opinions. Should the cut if unable to use a full tile be on the top row or the bottom?

[BES Plumbing @PlumbingBES]

@amyaddis 🤣

[BES Plumbing @PlumbingBES]

Wanted to stick with the same tiles but all new boards, base, tiles, tray and screen. No leaks and certainly looking much better!

[BES Plumbing @PlumbingBES]

Few weeks back but what a state this was tray waas far to small and those tiles!

[BES Plumbing @PlumbingBES]

@plumbmaid The state this cubicle was in was unbelievable! More water coming out on to the floor than down the trap. Reboarded, new tray to actually fit the area (original one was far to small 😬) new tiles(to match the other walls unfortunately) new shower screen. Problem solved

[BES Plumbing @PlumbingBES]

Refitted/repaired a shower cubicle and it wasn't straight forward. Last piece refitting the screen to the frame appears the holes are to large for the hexhead screw and no parts missing. Any suggestions? The brackets themselves dont move.

[BES Plumbing @PlumbingBES]

Looking for a flat surface panel rad. Any recommendations on manufacturer?

[BES Plumbing @PlumbingBES]

@pbplumber @YourPlumbing 🤣

[BES Plumbing @PlumbingBES]

@pbplumber @NocDewhurst @UKTalon Nice!

[BES Plumbing @PlumbingBES]

@cliveomalley @CTec_NI_Ltd The hacksaw blade down the back sorted it no problem. Thanks

[BES Plumbing @PlumbingBES]

Any tips? Replacing a shower screen and one of the side/guide rails has some glue securing it to the wall and wouldn't like the tiles to come off. Anyway to soften the glue?