Rob Stuart

Control Systems Masters @ODU Engineering. Drone Designer. Deltesian 3D Printer Inventor. ADHD Advocate.

[Rob Stuart @bornity]

@Swole_Medic @cursedconnector If you set the insert 2-3mm below the surface you can preload the plastic to achieve a similar goal. Bit of the blue lock tight to help the static breaking torque stay high.

[Rob Stuart @bornity]

@boxcardavid T-Motor Antigravity 4006 motor equivalent?

[Rob Stuart @bornity]

@RatioDrones Damn, this sounds like a fun project. Already working with another group. Wish you guys the best, your integration hell is going to pretty wild.

[Rob Stuart @bornity]

@Xaraphim @RatioDrones Hell yes! Absolutely the right approach.

[Rob Stuart @bornity]

@FrellingHazmot @YourAnonOne Guy under a parachute with a smoke flare.

[Rob Stuart @bornity]

@Ascii211 It's a dude on a parachute with a smoke flare caputred on a FLIR camera zoomed way in.

[Rob Stuart @bornity]

@solipsnitsyn @TierZoo That's the parachute... it's a FLIR camera video. There is a flare, just a smoke flare from the jumper. it's probably the golden knights or leapfrogs demo team

[Rob Stuart @bornity]

@TierZoo It's video from a FLIR camera zoomed way in on a parachute jumper with a smoke flair.

[Rob Stuart @bornity]

@The_Astral_ It's a parachute demonstration, probably leapfrogs or golden knights.

You're seeing a FLIR camera picking up the smoke flare.

[Rob Stuart @bornity]

@Xaraphim Parachute jump, trail is smoke. Once you find the canopy the motion lines up.

[Rob Stuart @bornity]

@ToviDing Yeah made a jig to cut the drop in notches on my router table. 6105-T5 cuts like 6061-T6, can use a table saw or router with the right blade/bit. Feed it in slowly, worked from the left and then the right against the cutter direction.

[Rob Stuart @bornity]

Figured I'd share my Railcore II modified into a Mercury Zero based on a Anycubic Chiron 410x430 bed. And using 1" 8020 extrusions for the frame.

[Rob Stuart @bornity]

@AzzyDesignWorks @LukesLaboratory @CanuckCreator Damn wire routing is good. Extra length is not as big a deal anymore.

[Rob Stuart @bornity]

@AzzyDesignWorks @LukesLaboratory I haven't seen that, he somehow he handled wire management is to make work

[Rob Stuart @bornity]

@AzzyDesignWorks The picture above is my in use Zero, not the SV08 lol. It's happened on both.

[Rob Stuart @bornity]

@AzzyDesignWorks Hahahaha it's such a pain to take the whole thing and turn it on it's ass to get at the underside

[Rob Stuart @bornity]

@AzzyDesignWorks Yeah, That shaft works it's way forward, invisible from the outside. Makes it looks like a low temp under extrusion issue

[Rob Stuart @bornity]

@AzzyDesignWorks Hmmm, that's a good idea. I don't have the Diamondback but do have Microswiss hotend

[Rob Stuart @bornity]

@AzzyDesignWorks I'm very confused, I've had issues with this on my SV08 and Zero

[Rob Stuart @bornity]

@AzzyDesignWorks No not getting anywhere near this temps for long print times without errors.

How did you fix the extruder idler shaft drifting out of the rear support?