I'm cancelling AutoCAD and Revit tonight: I built a free Claude skill that turns any industry into a live simulator and Fable 5.2 used it to build this construction project from bare dirt to finished walls.
i asked my own skill to turn construction into a live simulator and what came back is better than anything i had planned for it.
how it pulls that off:
> step 1 is homework: Claude pulls frames from a clip with the look i want and writes the camera, the colours and every panel down as numbers
> 2 Claude Code subagents get one brief and one scale contract and build the excavator, the trucks, the pit and the walls in parallel, 3,829 lines between them
> one line of light fixes the palette: Neutral tone mapping keeps the pale ground pale instead of office grey
> the app on top gets traced over a frame of that clip until every card sits where it should
> the whole job runs as a function of time: the pit digs, the concrete spreads and the walls rise on one clock and any second renders the same out of order
> a collision check combs the timeline in 0.1 s steps until no truck clips a digger
i made this skill myself and watching it run still feels like cheating.
the free skill and the full guide are in my article below 👇
@BobbyPL07@OJ_Smoke_ So what you find it further are you justifying their behaviour they are enabling regions to act independently by funding them
Is that legitimate
THIS SHOULDN'T BE POSSIBLE YET.
Claude Opus 5.5 took a 1,792 sf house in Colorado Springs and routed every MEP system from scratch.
12 supply registers + attic trunk
20 PEX home runs, 754 ft
10 fixtures drained and vented
19 circuits, 98 devices
Gas to furnace, water heater and range
1,784 parts in total.
Then it checked its own model against 2021 IRC, 2021 IPC/IFGC and 2023 NEC: receptacle spacing, GFCI, smoke and CO alarms, ventilation, trap arms, gas shutoffs.
10/10 passed. 0 clashes.
The first pass had 26 real clashes. It rerouted every one. On review it also caught 8 of its own code mistakes and fixed them.
It's a simulation on a plan made for this test. No load calcs or duct sizing yet, layout and code checks only.
Would you trust this as a first draft?
@lami_fixit@anesmansory@grok Stop funding it, he is asking stop funding our problems and conspiring against us
They are a rich country trying to destroy our country and won’t leave us alone
Leave us alone
@nas05___@Dubflip@alkharidie What are you talking about
It’s foul language anyway and unique culture of Black Americans only reason people want to say it is cause it’s seen as cool in popular culture
RC Slab Detailing (Refresher)
Let's detail a RC slab on the following assumed rebar diameter and spacing
Short span:
Midspan: T12@200mm c/c
Continuous edge: T12@150mm c/c
Longspan
Midspan: T12@250mm c/c
Continuous edge: T12@200mm c/c
Distribution bars: T10@300mm c/c
The bars are color-coded to aid quick understanding and easy of read. Sections are cut in both directions to show the rebar arrangement and callouts.