@RMBee@BillHuntBits I don’t know where these people came from but Nolan has done it this was for literally 20 years now. Even the London premiere was 5/70 2:20:1.
@JoshMurrah@ZombieHedgehog_ It might’ve switched (I’d heard they had purchased a mid-size filament maker sometime this year) but Bambu PLA used to just be Sunlu.
@TheCinesthetic It’s literally going to make around 10x budget WW and be the highest grossing Toho Godzilla ever made. Fall is due to loss of screens but Toho is likely thrilled and another sequel (probably a Shin Godzilla sequel) will be right around the corner.
@IMAX_cinema For IMAX shows without a special opening (IE: Godzilla) this is now the opening we see at the Bob Bullock GT Laser IMAX in Austin, Texas.
It’s very colorful! Lovely in 1.43:1!
@ZombieHedgehog_ Polymaker doesn’t make anything lower than a 95A durometer TPU right now. If I had to guess likely 85A along with a TPU-CF.
Wouldn’t be surprised if they make a 2.85mm 75A for the H3C either down the line. I think they still sell in that size for some of their filaments.
@macgy_ Brightness is not the only thing dual laser adds… the two 4K projectors are overlapped 1/2 pixel apart. This increases the perceived resolution of the image which is important with GT (Grand Theater) large screens. It’s why a 4K digital projection can look even close to film.
@skyfish_A_ This is from the Star Wars novels of the 80s/90s. All this stuff was later reconned by Disney.
Some of them are super good books though I love any Star Wars novel by Timothy Zahn. One of his characters, Thawn, has been brought over to Disney for ‘Rebels’ & ‘Ahsoka’